Mechanical knob-control ultrasonic cleaners in several sizes
Industrial ultrasonic transducers bonded under a stainless steel tank
Ultrasonic cleaner cleaning metal parts in a basket
Ultrasonic cleaner cleaning a PCB board
Commercial Ultrasonic Cleaners

Mechanical Ultrasonic Cleaner — 1.3L to 30L

Mechanical ultrasonic cleaner with knob timer and heater, 1.3L to 30L. No displays, no menus — the workshop-proof bench cleaner. OEM from 300 units.

Specifications

Capacity
1.3–30 L by model
Ultrasonic power
60–600 W by model
Heating power
100–600 W by model
Timer
1–30 minutes, mechanical knob
Temperature
Room temperature to 80 °C, knob control
Tank material
SUS304 stainless steel
Control
Mechanical knobs
Basket
Stainless steel basket included
Packaging
Neutral packaging
Private label
OEM / private label from 300 units
Certifications
CE, FCC, RoHS, UKCA, PSE, UL
The DS-T series is a mechanical ultrasonic cleaner with knob controls for the timer and heater, in nine sizes from 1.3 to 30 litres. No displays, no menus, nothing to configure — turn the knobs and it cleans.
Full per-model dimensions are in the specification sheet we send with every quotation.



Knobs that gloved hands can use
In a working garage or plating shop, controls get used with wet or gloved hands. Big mechanical knobs set time and temperature by feel, and the settings stay where they were left.



Nothing electronic to fail
There is no display board to fog, crack or fail. For buyers equipping rough environments — or renting machines out — a mechanical ultrasonic cleaner is the low-maintenance choice.



Heating to 80 °C
The heater knob holds the solution up to 80 °C, softening grease and carbon so the ultrasonic action works faster.



One-piece SUS304 tank, drawn with no welds
Every size uses a tank pressed in one piece from SUS304 stainless steel, with no welds or seams inside to trap residue, and a stainless steel basket is included.




What it cleans






Carburettors, injectors, chains, bearings, tools, moulds and greasy machine parts — the daily load of repair and maintenance workshops.


Simple controls, set with gloves on

Two mechanical knobs set the cleaning time and the heating, so an operator can set up a load in seconds and get back to work.
The knobs are large enough to turn with work gloves on, even with wet or oily. Because the controls are mechanical, there is little to wear out and little daily upkeep: no software updates, no touch panel to clean carefully, and no settings buried in menus.
Turn the timer knob to start a cycle, and the cleaner stops when the set time runs out. That simple routine suits workshops that run the machine many times a day, load after load, without slowing the bench down.

Where the DS-T works

In a car workshop, the DS-T cleans carburettors and fuel injectors, lifting carbon and old grease from small passages that a brush cannot reach. A load of injectors and small parts comes out clean together, ready for refitting.
Hardware workshops use it for bolts, nuts and small metal parts in batches, and repair shops use it for tools and chains. Parts sit in the basket during cleaning, so small pieces do not scatter and are easy to lift out.
Units ship in neutral packaging, so the cleaner can go straight to a distributor or a branded shelf. Private label and OEM start at 300 units, and the range is certified to CE, FCC, RoHS, UKCA, PSE and UL.

To request the full specification sheet or a sample, send an inquiry through the form on this page. Mob / WhatsApp / WeChat: +86 15920036975. Private label and OEM are available from 300 units, and units ship in neutral packaging.

Continue browsing

More products from the catalog

Pair it with other pieces from the same collection or routine.